Cubic Doggo Update: What does it takes to lift its feet up 4mm?
|
Update since: https://www.reddit.com/r/ROS/comments/1ugw66z/cubic_doggo_update_returning_to_basics_after_all/ Hello hello, I made some mechanical updates to Cubic Doggo 06R, just for it to lift its feet while walking. The black padding is measured to be around 4 mm thick. I really thought this would be simpler than the IMU, but with all the changes, this is as good as it can get. The servo load (3rd on for the feet joint) easily reaches 70%, so I have a feeling this is the best it can do. I hesitate to make the body's 3D-printed frame lighter because that can make it less sturdy, and most of the weight is from the servo and batteries (yeah, also, I get a bit lazy just thinking about all those bolts and screws). Any more suggestions would be great! The next step is to walk with IMU, and then finally going to do some simulation and RL. Original Cubic Doggo post. submitted by /u/SphericalCowww |